by admin | Jul 31, 2010 | Stringers
Stringers are extended by gluing them to each other for raising the length up to the whole length of the boat. Before lengthen the ends of stingers must be sawn to sharp angle (4-5 times length than the width of the stringer) for increasing the surfaces to be glued. To reach the well connected surfaces the cutting operation must be executed precisely. This way I made a pattern installed onto the saw to get the appropriate and same angles.
by admin | Jul 27, 2010 | Backbone
Backbone drawing came on mylar in 1:1 scale. To be made of plywood, Running from the bow to the aft. It means the centerline of the boat. Slots on each bulkhead are precut – slots must be run straight precisely.
by admin | Jul 8, 2010 | Bulkheads, Standing bulkheads
Vertical posts (on the building stock) are made from pine wood. These are fixed to the stock with M10 bolts. Bulkheads are fixed to the posts with the same bolts.
by admin | Jul 1, 2010 | Hull material
Ocume plywood sheets – marine grade – just arrived, Surface quality looks pretty good. CE conformity is essential when you build your boat in the EU.
JAF Holz Ungarn Kft