According to the plan and the designer’s descriptions I stitch the skin sheets to each other and the backbone. Diameter 0,8 mm copper wire I use to do that. Before gluing I’ve drilled small holes to the plywood sheets and the backbone and stitch them by the wire but not so tight. I need to lift up the hull sheets for gluing.

Before fitting the sheets I filled the screw heads holes and other sinkages with resin. I used Trecell and Silicell added to the glue mix to make the viscosity and the tixotropy higher avoiding the too thin layer of the resin.

Copper wires
Copper wires
Temporary stitching
Temporary stitching
Interesting matter happens here…
Interesting matter happens here...