First epoxy coat
First coating with low viscosity epoxy resin
First coating with low viscosity epoxy resin
After filling all holes with epoxy you can realize that the surface is actually much more worse than you first thought it would be. The hull surface is full with spots – holes and humps. They must be filled up, and another sanding have to be done.
You can use softer filler mixed into epoxy for easier sanding, however, I have chosen hard ones because the mechanical properties fit better for the hull even if they are below more epoxy layers.
Sugar scoop structure
Rudder will be profiled below the hull. The top of the rudder will be made of 25X4 mm stainless steel A316 tube.
Before turning the hull upside down all painting jobs have to be done. At least 4-to 5 layers of epoxy covers are needed before the final polyurethane painting can be sprayed on. The last layers – directly under the outer painted layer – must be UV resistant or at least have some UV stable ingredients if available.
Before starting the final epoxy layers (gluing & sanding & gluing & sanding) all rough faults must be repaired.
Backbone stich will be cut before epoxy fillets.
After planning the hull skin plywood sheet to reach the shorter base of the trapeze cross sectioned sheer clamp the capping has to be jointed between the deck and the hull skin must be prepared. It is made by 12 mm plywood.
After four months of rest it is time to continue the construction of the Didi26. The second layer is missing, so do the bow cap. Well, I started working with fitting the bow cap and continue the hull work setting the radius skin. Before setting the second curved layer of plywood to install the second diagonal layer of the radius skin area the skin must be sanded. The point is not to sand the surface of the plywood itself, but to the glued junctions and the filled-in holes screwed. Sanding the solid epoxy resin is very hard work, you need to be very careful during sanding not to scarf the surface of the plywood with a hard sander directly next to the mound of epoxy glue. If you are not careful enough you can easily make deep holes into the plan surface of the skin. It must be avoid.
Bow cap was installed by mahogany. It is screwed and glued onto the edge of the bow as a cap. Sides of cap are planned the same even as the flat area of the hull from the upper tangent to the sheer clamp.
If you want to avoid the breach or slit of the thin plywood layer when you bend it, you may apply some tricks: use much more longer plywood piece of band than you have to as longer grains have higher bent resistance.
I have started planking the hull from the aft next to the stem therefore the bow remained to the end.